Nanotechnology Now - Press Release: NIST Develops Test Method for Key Micromechanical Property

Home > Press > NIST Develops Test Method for Key Micromechanical Property

Abstract:
Engineers and researchers designing and building new microelectromechanical systems (MEMS) can benefit from a new test method developed at the National Institute of Standards and Technology (NIST) to measure a key mechanical property of such systems: elasticity. The new method determines the "Young's modulus" of thin films not only for MEMS devices but also for semiconductor devices in integrated circuits.

NIST Develops Test Method for Key Micromechanical Property

GAITHERSBURG, MD | Posted on January 9th, 2008

Since 1727, scientists and engineers have used Young's modulus as a measure of the stiffness of a given material. Defined as the ratio of stress (such as the force per unit area pushing on both ends of a beam) to strain (the amount the beam is deflected), Young's modulus allows the behavior of a material under load to be calculated. Young's modulus predicts the length a wire will stretch under tension or the amount of compression that will buckle a thin film. A standard method to determine this important parameter—a necessity to ensure that measurements of Young's modulus made at different locations are comparable—has eluded those who design, manufacture and test MEMS devices, particularly in the semiconductor industry.

A team at NIST recently led the effort to develop SEMI Standard MS4-1107, "Test Method for Young's Modulus Measurements of Thin, Reflecting Films Based on the Frequency of Beams in Resonance." The new standard applies to thin films (such as those found in MEMS materials) that can be imaged using an optical vibrometer or comparable instrument for non-contact measurements of surface motion. In particular, measurements are obtained from resonating beams—comprised of the thin film layer—that oscillate out-of-plane. The frequency at which the maximum amplitude (or velocity) of vibration is achieved is a resonance frequency, which is used to calculate the Young's modulus of the thin film layer. The group also developed a special Web-based "MEMS calculator" ( http://www.eeel.nist.gov/812/test-structures/MEMSCalculator.htm ) that can be used to determine specific thin film properties from data taken with an optical interferometer.

Knowledge of the Young's modulus values and the residual strain (using ASTM International Standard E 2245) for thin film layers can lead to calculations of residual stress, which in turn, enable semiconductor manufacturers to develop circuit design strategies, fabrication systems and post-processing methods that could increase fabrication yield by reducing the frequency of failures from electromigration, stress migration and delamination.

SEMI Standard MS4-1107 is available for purchase from SEMI, an international industry organization serving the advanced manufacturing community, at
http://dom.semi.org/downloads.nsf/standard?openform&did=618EF551D3C0F6798825736300487EED&sid=0 .

####

About NIST
Founded in 1901, NIST is a non-regulatory federal agency within the U.S. Department of Commerce. NIST's mission is to promote U.S. innovation and industrial competitiveness by advancing measurement science, standards, and technology in ways that enhance economic security and improve our quality of life.

For more information, please click here

Contacts:
Michael E. Newman
michael.newman@nist.gov
(301) 975-3025

If you have a comment, please Contact us.

Issuers of news releases, not 7th Wave, Inc. or Nanotechnology Now, are solely responsible for the accuracy of the content.

Bookmark: